voltage monitoring on iEFIS lite
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
voltage monitoring on iEFIS lite
Is it possible to monitor two bus voltages on the iEFIS lite series?
Re: voltage monitoring on iEFIS lite
Bump. Rainier?
Re: voltage monitoring on iEFIS lite
Yes.
You need the Extender.
Configure one of the analog inputs as you need.
Input voltage range goes up to about 15V - you can extend that with a series resistor (which forms a voltage divider with the input resistance) if you need to monitor a higher voltage.
You can simulate all of that in the simulator with simulated voltage. Set the scaling the way you want it (probably in 0.1V steps). Place readouts and or indicators attached to your chosen input as needed.
Rainier
You need the Extender.
Configure one of the analog inputs as you need.
Input voltage range goes up to about 15V - you can extend that with a series resistor (which forms a voltage divider with the input resistance) if you need to monitor a higher voltage.
You can simulate all of that in the simulator with simulated voltage. Set the scaling the way you want it (probably in 0.1V steps). Place readouts and or indicators attached to your chosen input as needed.
Rainier