MGL Avionics User Forum

Ok, thanks!!!
Steve

Thanks Stuart,
Thought it was but double checked and it wasn’t so I switched it off, now shows .1 bar with engine off, I did read on sending unit it says says 4 ma =.75 bar and 20ma =10.75 bar if that matters?
Steve

Installing EMS2 on my rotax 912 with the newer 4-20Ma oil sender, set up everything according to manual and I’m getting 1.9 bar oil pressure with engine off, I installed the supplied resistor, any ideas please!
Steve

Having trouble programming analog channels 3 and 4 for the newer 912 rotax chts, 4.5.1 Special Rotax 912/914 probe mode In this mode the Analog Channel 3 and Analog Channel 4 (or RDAC AUX 1 and AUX 2 analog input channels) become the Rotax CHT channel 1 and CHT channel 2 respectively. All CHT setups...

In the installation manual it shows hooking up the ptt switch with a shielded cable, is this necessary or can it be just hooked up with a single ground wire from a ray Allen stick control?
Thx, Steve

In the installation manual it shows hooking up the ptt switch with a shielded cable, is this necessary or can it be just hooked up with a single ground wire from a ray Allen stick control?
Thx, Steve