I am a small maintenance shop in Central Oregon. I have a customer who is having problems with his mini efis. I am new to the MGL family but I am familiar with general efis installations and wiring techniques.
I have looked on the web site at the install manual but I need a little more information to properly wire the system in my opinion .
I have the mini efis with the sp6 , sp7 compass and ahrs with a remote transponder.
Does any one have a schematic showing the interface to the different devices and a serial setup for this system?
Thanks for the forum support
JH
aiskrdm.com
interface drawings
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Re: interface drawings
Nothing much needed here.
It's all CAN based - throw everything on the CAN bus and supply power and ground to the devices and you are done.
Don't forget the CAN termination resistor(s). Not going to work without.
It's all CAN based - throw everything on the CAN bus and supply power and ground to the devices and you are done.
Don't forget the CAN termination resistor(s). Not going to work without.