Hi,
I want them to send the GPS signal from the LX to MGL FF4 in order to calculate range. I don’t have a MGL RDAC. I have a LXNAV RS485 splitting unit, but I think I don’t need to use it.
If anyone has done something similar can you guide me, step by step, how to do it?
I think I need to use 1 cable connected to the PDA port in the LX and use cable on pin 5 (Output - data out RS232 - transmit line) . This cable I should connect to the purple cable (12) in FF4 (CAN Lo). And what about ground? Do I also need to connect? In this case it would be cable 1 (or 2] on the LX side to cable black (2) on the FF4.
For the LX please check page 52 of installation manual: https://gliding.lxnav.com/wp-content/up ... _rev39.pdf
Is this correct?
Thanks in advance,
Joaquim
LXNav 9070 and MGL FF4
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Re: LXNav 9070 and MGL FF4
Hello.
You want to connect the LX RS232 Output to the FF-4 RS232 Input, e.g DB15-Pin 4.
The harness delivered with the FF-4 may not contains a wire to DB15 pin 4
Make sure both devices use same Baud Rate
You want to connect the LX RS232 Output to the FF-4 RS232 Input, e.g DB15-Pin 4.
The harness delivered with the FF-4 may not contains a wire to DB15 pin 4
Make sure both devices use same Baud Rate