I have a Extreme and a RDAC XF and I also have a EMS-2. I have setup the Extreme with the RDAC and all the sensors work fine but slaving the EMS-2 on the CAN bus not all the parMTERS ARE CORRECT ON THE EMS. THE OIL TEMP AND OIL PRESSURE HAVE WRONG VALUES LIKE THEY ARE NOT CONNECTED. ON THE CAN BUS I WOULD HAVE THOUGHT ALL THE PARAMETERS WOULD BE DISPLAYED ON THE EMS. oops sorry about the caps.......All the paramters on the EMS are referenced to the RDAC on the setup. EGT and CHT work all ok
Any ideas. I am pretty sure I have everything setup correctly
EMS-2 with Rdac XF and also Xtreme
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Re: EMS-2 with Rdac XF and also Xtreme
Select RDAC for the Data field under the analog setup menus.
Re: EMS-2 with Rdac XF and also Xtreme
Hi Franz
I have done that on every parameter on the EMS-2 that has the RDAC selectable and also selected number 1 on all of them.
Also my Gen2 Xtreme does not display the 6 paraamters in the top right of the display as shown in the Gen 2 manual. I have the latest 2.08 firmware. I did a post about it as well
I have done that on every parameter on the EMS-2 that has the RDAC selectable and also selected number 1 on all of them.
Also my Gen2 Xtreme does not display the 6 paraamters in the top right of the display as shown in the Gen 2 manual. I have the latest 2.08 firmware. I did a post about it as well