Page 1 of 1
RDAC FX oil pressure
Posted: Fri Feb 04, 2022 8:48 pm
by lamber
I would like to use a 0.5 to 4.5 volt electronic pressure sensor/sender. How should I calibrate that sender on my Xtreme EFIS?
Re: RDAC FX oil pressure
Posted: Tue Feb 08, 2022 2:51 pm
by rainier
Select the 0.5V-4.5V sender in the oil pressure setup menu after selecting "Voltage type".
Re: RDAC FX oil pressure
Posted: Tue Feb 08, 2022 5:58 pm
by lamber
My Xtreme EFIS is a gen 1 and does not have a 0.5-4.5v selection, only 0-5V.
Re: RDAC FX oil pressure
Posted: Wed Feb 09, 2022 12:00 pm
by rainier
You could still use it - it will be accurate at mid range with a rising error towards zero and max pressure but not worse than 20% at the extreme...