MGL Avionics User Forum

I am a small maintenance shop in Central Oregon. I have a customer who is having problems with his mini efis. I am new to the MGL family but I am familiar with general efis installations and wiring techniques.
I have looked on the web site at the install manual but I need a little more information to properly wire the system in my opinion .
I have the mini efis with the sp6 , sp7 compass and ahrs with a remote transponder.
Does any one have a schematic showing the interface to the different devices and a serial setup for this system?
Thanks for the forum support
JH
aiskrdm.com

Nothing much needed here.

It's all CAN based - throw everything on the CAN bus and supply power and ground to the devices and you are done.

Don't forget the CAN termination resistor(s). Not going to work without.