Hi,
A question relating to the XTreme EFIS. Is it possible to make this a non terminating node on the CAN bus?
For ease of wiring it would be advantageous to have this, trying to eliminate extra cable weight and bulk in a small aircraft (I know its minimal for both but it is an aerobatic aircraft and I'm conscious of every small thing adding up). My intention is to have the SP-6 and SP-7 in the aft fuselage (or possibly one wing) and RDAC engine side of the firewall. This would place the XTreme in the middle of cable runs and ideally I would like to remove the need to have a return cable from either the RDAC or the SP-6/7.
My thought is to have the RDAC as one terminating end with resistor cable running to the XTreme (non terminating node) and then onwards to the SP-6 (non terminating node) and finally to the SP-7 (terminating).
Feasible? Any potential issues?
Thanks.
Xtreme EFIS
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.