Hello
Iefis lt Challenger with V16 comm radio, Razor controller, Sandia transponder ans uAvionix ADS B
Using the instructions on the tech support page for iefis lt to v16 comm connections and Sandia Transponder with uAvionix ADS-B. My system is MGL wiring harness with the extender for AOA
I'm getting the red X for both the radio and transponder.
Serial port routing allocations are set to
The MGL NavCom 1 radio is set to SR232 port (1 internal)
The Sandia is set to RS232 port 2 ( external )
The radio, transponder and extender module are all enabled in the equipment list
What am I doing wrong?
Thanks
DEW
iEFIS lt to V16comm setup
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Re: iEFIS lt to V16comm setup
have you wired them correctly TX->RX and RX->TX ?
Re: iEFIS lt to V16comm setup
Beats me Rainier
What a depressing thought.
Thats why I bought the prewired harness from MGL.
But it wont surprise. Guess I know what I'll be doing this weekend.
What a depressing thought.
Thats why I bought the prewired harness from MGL.
But it wont surprise. Guess I know what I'll be doing this weekend.
Re: iEFIS lt to V16comm setup
Just a thought - make sure your EFIS is in fact running a later version of firmware - if your firmware does not know the V16 it will not be able to detect it.