hello Rainier, i have an interesting problem with the temperature sensors (oil and cht). the sensors showed the correct temperature until i calibrated the fuel level transmitter. both sensors then show 20 degrees less. I have attached the pictures. Both sensors and the fuel level sender are connected to the same minus (engine block). I've also tried to separate them, but the error is the same. where is the problem, has someone had a similar problem.
Greetings
Christoph
CHT and Oiltemperature sensors issur
Forum rules
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
Please keep your posts friendly and on topic. No politics or discussions of a controversial nature not related to our favorite subject of flying and avionics. Offending posts may be removed or moderated.
-
- Posts: 12
- Joined: Wed Feb 10, 2021 8:28 am
CHT and Oiltemperature sensors issur
- Attachments
-
- 20210513_165451.jpg (25.23 KiB) Viewed 5439 times
-
- 20210513_165425.jpg (28.92 KiB) Viewed 5439 times
Re: CHT and Oiltemperature sensors issur
Hi Christoph,
Is this the Xtreme-EMS or EFIS unit? What firmware are you running?
Regards,
Franz
Is this the Xtreme-EMS or EFIS unit? What firmware are you running?
Regards,
Franz
-
- Posts: 12
- Joined: Wed Feb 10, 2021 8:28 am
Re: CHT and Oiltemperature sensors issur
Hi,
this is the xtreme efis. The software is the newest (2.06)
Greetings
Christoph
this is the xtreme efis. The software is the newest (2.06)
Greetings
Christoph
-
- Posts: 12
- Joined: Wed Feb 10, 2021 8:28 am
Re: CHT and Oiltemperature sensors issur
After spending the whole weekend on the wiring and checking, I come to the conclusion that the RDAC must be damaged. In the analysis, I disconnected all sensors and reconnected again one after the other. During this, I observed the ADC values of the CHT, AUX, OILp. and OILtemp sensors. The result is pretty depressing. Whenever I disconnect a sensor, the ADC values of other sensors also change. In the pictures you can see how the values change when disconnecting the fuel level transmitter, the values of oil pressure, CHT temp.,oil temp and AUX chnged. The bad thing is, that if I disconnect the second
sensor, the values continue to change. When I ended up only connecting the CHT and not the other sensors, the temperature value was 80 ° C. That can't be right. Maybe I did something wrong, but it can't be that if one sensor changes the resistance, the other sensors also change the measured values. Or am I doing something fundamentally wrong?
- Attachments
-
- after dsconnected fuel level sender
- WhatsApp Image 2021-05-23 at 22.39.26.jpeg (114.4 KiB) Viewed 5353 times
-
- Before disconnected fuel level sende
- WhatsApp Image 2021-05-23 at 22.39.41.jpeg (137.91 KiB) Viewed 5353 times