MGL Avionics User Forum

Not really that happy with the slow rising edge of the signal you are showing. Rainier thanks for the reply, what do you think about this pulse pictured below. This fuel flow sensor pulse was taken with the engine being ground run and after I found the problem of the fuel tank level sensors being i...

Hi All, I asked the question about the K-factor in my above post and I had not googled K-Factor, so I did this morning and it bounced back with many pages, but it was the K-Factor in aviation that caught my eye, I found this article and it answered many of my questions. I have put this screen shot u...

Hi All, I had the opportunity to put an oscilloscope over my Tacho/RPM pulse coming from one of my ignition Coils. Whilst I feel my Voyager EFIS RPM is working OK, it does seemed to be a bit flaky at lower RPM's and this scope picture might be showing why. I do have a resistor in the cable from the ...

Can anyone tell me what the k-Factor number for the fuel flow sender means. Is the K-Factor a number of pulse equal to a known amount of fuel going through the meter? I see that different flow meters have different K-Factors so this makes me think the K-factor is a standardized meaning or value. I p...

Oh, yes Bill, those knobs do the radio frequency as well. I set those two knobs for the Heading and Alt some time back and have not changed their configuration since and had forgotten about them controlling the radio frequency. Thanks Bill, I will look at that, as a way for what I am trying to do. C...

Oh boy, thanks Peter,

I finally found it myself in the Voyager Sim menu system and just posted the path in the Radio Section of the forum and was coming into the EFIS section to do the same when I see your replied.

Thanks so much for your reply.

Cheers
JimJab.

Hi All, I found the answer to my question, I don't know how I could have missed this, but I did. It's possible to change where the Voyager will transfers the frequency to in the V10 or V6, Active or Standby. I was sure Rainier would have programmed this feature in. So in the Voyager Menu System, go ...

Hi All, My Voyager EFIS's are connected to the V10's and I can select a coms frequency on my EFIS and it is transfer to the active frequency of my V10. I thought I had seen or read some where that you can change where the frequency is entered into the V10, either into the Active or standby frequency...

Hi, My Voyager EFIS's are connected to the V10's, where I can select a coms frequency form EFIS and it's transfer to the active frequency of the V10. I thought I had seen some where in the Voyager EFIS menu systems or manual where you have the option to have the EFIS frequency transferred into the s...

Mark which Country are you in, Australia?