MGL Avionics User Forum

Great info. Thanks JimJab!

It fixed my interference issue

Hey Dan,
Yes you can have 2 virtual tanks. Go to the System Setup Menu and then select Fuel Related Setup and all your settings are there.
Also, thanks to a recent update, you can set low fuel warnings on these virtual tanks as well which you will find in the same menu selection.

Hi Geoff, I have what I think is a similar problem. My canbuss route is from the efis lite to the ecbs ,rdac , compass and ended at the servos. Lights flashed properly on the ecbs and rdac and not at all on the compass or servos. I checked the terminating resistor and the canbuss voltages were 2.3v ...

I wasn't impressed with my Avioguard either. Sitting on the shelf.

Courtesy of Michigan Avionics:
https://support.michiganavionics.com/po ... FAA_cycles

Here are some step by step instruction that should help. Select MENU Then select SYSTEM SETUP MENU, Go to the second page and you should see this: IMG_0962.JPG Select ENABLE AOA CALIBRATION and the screen should disappear and return to your main screen Press MENU and go to the second page and you sh...

It's been awhile but I believe it is in System Setup menu. It is obviously done in flight and I think it is a cruise setting and a caution as well as stall setting. Once reaching the appropriate speeds you select each of the three to calibrate.

I copied this reply from Ranier on another thread. It might help you out..... If you are not getting consistent readings - consider what the EMS sees. What does it measure ? It measures a voltage between an input and it's own power supply ground. That voltage is either created by some sensor or it i...