MGL Avionics User Forum

Thank You Bill for stating the obvious, I had miss the obvious or more that
I was not looking in the right place....

I did when I installed it but I guess I will have to do it again.
Thx

Trying to set-up using version 1.1.2.2 and it's not seeing the RDAC and my version1.1.1.0 does????
Any hint???

Regards

Hello all..
For the past couple of week, as soon as I start my Xtreme in the plane and the engine oFF
It shows 18MPH and i'm definitely not moving

In the air it shows the same speed than my Challenger.

Hello everyone.

I have put the Raster (.MAP) in the MMC folder and in the Task Menu I have loaded
the Maker2 .MAP and it puts the message that they were loaded but I'm just seeing a black map
when I pick Raster from the Map Menu.

What obvious thing am I missing, this was ok some time ago.

Regards

Hi Everyone.

Anyone has their Efis connected to a Trio Autopilot???
I currently have my AP connected to an Ifly740b but looking at merging the AP to my Challenger Lite.

Regards

Gidday everyone... I have an Xtreme and a Challenger. I'm trying to setup both Efis with the Rdac Xf. The one sensor I'm having issues with is the Fuel Pressure, the sensor being a UMA 2 BAR I was able on the Xtreme by picking TYPE (resistive) SENDER (vdo) MODEL (2bar) to work properly. On the Chall...

Thx for response...

I'm using DB9 with PCB board to connect wire instead of the welded pin type,
Long story short the numbers order number on the board were wrongly identified.
As Soon that I used the right order and applied the voltage I got the blinking LED.

Regards

I'm at home and before installing the SP-6 in the aircraft I wanted to check the calibration interface program.
I've connected the +12 to pin 6 and ground to pin 1.

Should the LED comes ON???? Mine isn't.

Regards