MGL Avionics User Forum

The easiest way:

PTT going to V16 from audio panel - splice a wire here and send it to TX Interlock in on the GTR 200
TX Interlock out from GTR 200 to single interlock pin on V16

Adam

A saga it can be, as I can't make the EFIS fault in the plane on the ground, running the engine at all rpm's with all other avionics and lighting as I do in flight. I even tried getting the instrument panel hot by baking the plane in the hot summer sun, but the EFIS still worked flawlessly on the g...

There is a hardware upgrade path to G3 since it was released for G2 customers. Depending on where in the world you're in, you should be able to send the EFIS to your nearest MGL distributor and have the upgrade performed. Do take a backup of configuration, screen designs, anything you want saved etc...

What a saga, Jim!

I'm posting to follow this thread, as I'm interested to see what your investigation will bring to light.

Adam

“ iPad mini running other pilot software”. Can you tell me what software you use to see the ADSB objects. I have a iPad with ForeFlight.. Most any software will suffice, including ForeFlight. If the ADS-B receiver you are using has a way to wirelessly connect, then chances are ForeFlight is support...

Hi Rudolph, The MGL crew is on holiday until January 6, so it takes just a bit longer to get posts approved at the moment. The answer to your question lies here: http://mglavionics.co.za/iefisg3updates.html Click the installation instructions link and look at the bottom paragraph regarding instructi...

For anyone who finds this post, Ian and I have worked to find the solution to this issue. In Ian's case, the intercom volume for the pilot and copilot were set too low, and so he was compensating for this by cranking up mic gain, and overloading the mic channel. Once we cranked the intercom volume u...

Loman, The Pin 4 and high current inputs are likely diode-isolated, so if, for example the high-current terminal (referred to from herein as HC) voltage is higher than Pin 4's voltage, it "overpowers" it, and because there's a diode to prevent reverse current flow, the pin 4's voltage will never equ...

Thank you for the detailed explanation of how it works. I ran down to the hangar and sure enough, I had failed to set the auto detect. Activated the start flight and the EFIS showed that it was recording. Looking forward to some VFR weather and putting the recording to work later this week. Good to...

Rainier,

I see the uBlox chip on the SP-14 - built-in GPS?

Adam