MGL Avionics User Forum

can someone please explain the filter parameter when setting up fuel levels?

Thanks

Sorry, Did you mean can’t?

Anyone know if possible to wire fuel level senders direct to the FF-4 but get fuel pressure and flow from RDAC? Unlike my EMS-2, the set-up menu selection of source (INTERNAL or RDAC) appears to be selected at the top level (i.e. fuel data source) in the FF-4 menus rather than at the individual data...

Crap, now I’m completely lost. Engine is nicely grounded to firewall single pass-through bolt (the other side of which is the battery connection and a “forest”). But, Vans transducer manifold attaches directly to firewall (as shown in my previous post) and isn’t electrically isolated from it - its m...

Thank you, so here is where I think I'm headed then: https://www.flynesa.com/wp-content/uploads/2020/12/Engine-Wiring.jpg The GND bus bar shown would be for the RDAC only and is isolated from the airframe so that all attached sensors and the RDAC are essentially direct to the Engine. The reason the ...

Ok - I need a little education/confirmation. New to MGL and CANBUS in general. If Anyone can help would be great! The wiring schematic in the EMS-2 manual seems to show a 1200 ohm resister between the CAN LO and HI pins to be added to the DB connectors on both ends of the twisted pair cable between ...