MGL Avionics User Forum

Thanks Rainer - I swapped the thermocouple inputs at the RDAC and at least it now works in the right direction but still doesn't seem 100%. The readings aren't linear with throttle movement and one is showing 200degC hotter than the other which it never did before. I find it very strange that I woul...

I may try swapping the EGT imputs tomorrow but even that doesn't make any sense as the ambient is showing positive!! Doesn't go negative till after starting.

None at all Adam - that is what has me confused. Just tapped the MX1 to the CAN Bus after the Xtreme EMS and tapped an SP-6 to the CAN Bus before the RDAC XF. Never touched the EGT imputs at all.

Even with the MX1 turned off, the EMS still reads the same.

Make that an RDAC XF

Hi, I have an Extreme EMS wired via CAN Bus to the RDAC XP. It has been working fine. I have now added an MX1 and hooked to the CAN Bus. Everything works fine EXCEPT for the EGT's which seem to sit pretty much correct at ambient (about +26deg C) but as soon as I start the engine, goes into negative ...

OK - thanks Rainier.

Hi Rainier, Thanks for your reply. I am always totally impressed with your quick replies and great knowledge of all of your products!! I was very careful when ordering to specify I needed a 'post' S/No. 2008xxxxxx as per the advice on the Website so that I got the version which could be converted. Y...

Thanks for your replies Paul and Rainier. Will investigate both.

Hi again Rainier,

Also - is there an interface yet for the MX1 to control the Trig TY91?? I do have the Trig Control Head.

Thanks again - Don