Search found 4 matches
- Tue Aug 24, 2021 5:52 pm
- Forum: EFIS Systems
- Topic: Screen design
- Replies: 4
- Views: 3278
Re: Screen design
JimLab It is definitely the sim. I had all the bar graphs working. Both EGT and CHT. I changed from "bargraph Temp/TC probes shows" to "TC1-12 as EGT/CHT" as applicable along with selecting the appropriate channel. Then all of a sudden the CHT bar graphs stopped moving when moving the sliders, excep...
- Tue Aug 24, 2021 3:27 pm
- Forum: EFIS Systems
- Topic: Screen design
- Replies: 4
- Views: 3278
Re: Screen design
JimLab Thank you for the reply. I have not bought the unit yet as I'm not quite ready for it. Panel is cut and ready to go, just need to finish up some other items. I'm going to use the Challanger. I have started the screen design early so that when installed I can load and go. When I manipulate the...
- Fri Jun 25, 2021 10:39 pm
- Forum: EFIS Systems
- Topic: Screen design
- Replies: 4
- Views: 3278
Screen design
I'm working on screen designs. Using a line Bargraph for each individual cylinder head and exhaust temp. I utilized the "bargraph shows" selection: Temp/TC probe, along with selecting the channel to match. When the using the RDAC sensor, the bar graphs do not show any output. When the oil temp/press...
- Thu May 20, 2021 5:24 pm
- Forum: EFIS Systems
- Topic: SP-6 tilt compensation
- Replies: 1
- Views: 1733
SP-6 tilt compensation
From the MGL Avionics SP-6 Magnetometer SP-7 AHRS installation manual page 2 states: "Alternatively, if you have a SP-7 AHRS connected to the same Airtalk bus as the SP-6, the SP-6 will use the attitude data from the SP-7 to calculate the heading. If your SP-6 is set to gyro mode and horizon data is...