MGL Avionics User Forum

Thanks for the explanations, that Odyssey I had was amazing I flew behind it for ten years without any problem at all after it was set up.
I still have to tune things on this new iEFIS but it show very nice capability also.

Thanks
Sylvain

Hi, I just installed a Chalenger IEFIS with a V16 radio on my airplane , the audio is working I am greeted with the usual ''GPS Available '' and ''Waypoint Arrival' every time I energize my panel. I have set the alarms low and high for most of the sensors connected to my RDACS. The problem I have is...

OK I found it, I need to enable custom info screens in the menu, then it all work fine. I will get beter at navigating the menu

Thanks

Hi all I have this problem designing the page number 4 on my EFIS Chalenger. For some reason I can not get the info screen to appear when I close the design mode. I get the flight screen, the engine screen, the fuel screen, I can see the info screen in design mode I can mouve it around but the momen...

It look as the only possibility is to have a second Chalenger screen next to the first unit. No wifi or other possibility to display a specific screen on a tablet or another LCD that would be less costly than a real Chalenger unit.

Thanks
Sylvain

Thanks all for your input, at least I know it is not something I am doing wrong, as far as I can remember the simulator of the Odyssey that I used on a different project was working fine with all the simulated RDAC inputs. Usually if it did not work on the sim it did not work on the instrument eithe...

Hi all, I am trying to customize screen for my new IEFIS Chalenger, I run in his problem in the simulator that the 2 fuel tanks bargraph that are linked to the RDAC number1 in a 2 RDAC system are not responding to the RDAC simulator cursors position setings. I have a full tank #1 and a halftank #2. ...

Hi all, I am installing a Chalenger iEFIS with it's iBox in an airplane, I would like to know if it is possible to connect somehow with the iBox or the iEFIS with a Ipad or android tablet to see one page of the system. Actually the starting page where I have all the engine parameters . I would like ...

Hi all, Please can you confirm that I can connect a Blaze RPM 2 input signal to the AC voltage of a geared 12V alternator. I have connected to a RDAC before on an Odyssey system with great succes, with a 24V geared alternator. I would like to confirm that I can do the same with the Blaze RPM 2 unit ...

Hi,
What could be wrong with this instrument if it's conversion of units is wrong. Should I try to reload the firmware or should I return the unit to the suplier.

Thanks